Volcano Vaporizer is one of the most efficient unit that is available today in the market. The vapors produced are devoid of impurities and contain flavored and aromatic plant substances. Vapors are produced at a particular temperature which does not let plant substance get burnt. Vaporization does not involve combustion or excessive carbonization as is the case with smoking. The process of vaporization is least harmful to the respiratory system and does not destroy the essential parts of the plants.
Following are the instructions that one should follow when using a Solid Valve Volcano Vaporizer -
- Remove the filling chamber and insert the filling with sufficient amount of herbs.
- Put in the filling chamber and lower the screen with the help of a pin. It will make the content of the filling chamber loosely fit between the screens. Make sure that the filling chamber touches the top edge of the filling chamber cylinder. Do not let the plant material bend or obstruct the screen.
- Now put the filling chamber on the exhaust vent of the Volcano Vaporizer. Push the green button with ‘Air’ written on it, to turn on the air pump. Before the vaporization procedure begins the grounded herbs have to be preheated for some seconds.
- Connect the balloon with the help of the valve that is attached to it to the filling chamber. Fix the valve on the filling chamber from above until both the gripping fixtures are engaged. The vapors of active ingredients will slowly fill the balloon.
- Fill the balloon with adequate amount. Do not let it overfill with vapors. The amount of vapors contained in the balloon should only be able to exhaust out within 10 minutes.
- Now detach the balloon from the filling chamber by pressing the grippers together. The valve closes automatically. This will prevent the vapors from escaping. Put the filling chamber on an insulated and heat-proof surface.
- After this connect the mouthpiece to the valve balloon and make sure that both the grippers are attached properly.
- Start inhaling by putting the mouthpiece to your lips, pressing your mouth against the mouthpiece. Pressuring the mouthpiece will make the valve open and let the vapors pass out from them. Removing the pressure from the grippers will make the valve close automatically, so that not even a small amount of vapors cannot be lost.
- After inhaling the content of the balloon, pull it tight to make it empty.
Solid Valve Vaporizer Cleaning and Maintenance
Cleaning and properly maintaining the parts of the vaporizer increases the efficiency of the vaporizer and is also very important for the purpose of hygiene. Clean the mouthpiece, filling chamber and valve with the help of spirit or ethyl alcohol with paper or cotton towels. Dish-washing liquid with warm water can also be used to cleanse the parts of the vaporizer. All three parts can be easily disassembled. Disassembling the parts will enable you to clean the parts thoroughly.
Sometimes a single vaporizer is used by more than one person, in these cases maintaining the hygiene is very important. Hence, clean the vaporizer regularly and replace the part which are no longer in working condition.