Following are the instructions one should adhere to in order to get an exhilarating experience. With the advanced Vapor Tower, your definition of vaporization will completely change.

1. Turn the knob to 12 Noon upto 5 minutes to heat the Vapor Tower. Keep in mind that the heater is very powerful and you should never use vaporizers at high temperatures if you are not experienced. The heater is powerful enough to burn your material and even your lungs!
2. Finely grind the material to get the best results. Turn the Vapor Tower glass hand-kit to load the herbal substance into the metal fitting of the bowl. Never overfill the chamber and only load it enough that it is just from the covering of the screen.
3. Cautiously put the hand-kit back together and avoid any spilling of the herbal material. If the hand-kit is fully loaded then do not screw it completely, but if it is loaded lightly then fit it completely.
4. Now insert the hand-kit back to the Vapor Tower and start by puffing fast and slow. It is important to begin fast but gradually slow down the rate of inhalation as it will help you draw hotter and stronger puffs. For every fast toke, take a short and slow puff. Keep on innovating with the method and changing the knob until you find the most suitable temperature and your ideal puff range.
5. Now very carefully remove the hand-kit and look into the material. If the material is blackened then turn the knob or start drawing faster. The glass and the metal parts would be very hot, so be extra careful in handling the apparatus. If you still do not get a swoop of air, then turn up temperature a little and draw in very slowly. It may not appear as if you have got a puff as by now it must have dissipated to a cool clear oil mist, which is only seen when blown against a light source. After constantly using the vapor tower, you would notice that material has exhausted and has become devoid off its essential oils.
6. Unscrew the hand-kit, after all the material has been utilized. Expel the resin or the residue of the substance by turning the bowl upside down. You can also use the stir instrument to scrape off the material that is stuck to the sides. Be careful not to lose the silicone rubber O-ring or screen.

Maintaining a Vapor Tower

It does not involve any elaborate procedures. One only has to pull glass, screen and the tubing apart to clean them separately. To clean the screen, one has to hold it over a flame and burn off all the residue that is left on it. For the glass, if there is a buildup, then only put the hand-piece in alcohol overnight. The silicone tubing can be washed under hot water or purchased from a hardware store of size 7/16” inner diameter and 5/6” outer diameter. Other sizes that easily fit and make an air tight seal with the glass would also be fine.

This entry was posted on Wednesday, September 24th, 2008 at 3:06 am and is filed under Instructional. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.