The Hot Box Vaporizer is one of the few revolutionary vaporizers that are present in the market today. Its sophisticated structure helps it to extract the vital ingredients from the substance and produce an essence and oil that is not only soothing but healthy as well. When attached with the aromatherapy attachment, the Hot Box vaporizer diffuses the calm flavor throughout the room.

Following are the instructions that are to be kept in mind when using the Hot Box vaporizer.

Step 1: Plug in the Hot Box Vaporizer (unit) cord into the socket and switch on the unit by turning on the button present on the cord and wait for the lamp to light.

Step 2: It will take about 15 minutes for the vaporizer to reach its optimal temperature. The time consumed would be more if you are using extension cords. Make sure that you set up the system away from the reach of children.

Step 3: Grind finely and properly.

Step 4: Pack down the finely grounded substance into the Wand and onto the screen through the narrow end of the Upper Wand piece either with the end of the tubing or some utensil that will easily fit into the open end of the Wand. Make sure that the substance loaded into the wand is no more than 1/3 volume of the wand, up from the screen. Extra packing of material will only lead to charring or burning.

Step 5: Holding the Wand against the tip of the glass heating element and inhale through the tube. Do not apply excessive pressure onto the glassware lest it may break. Using broken glassware will only lead to damaging of unit and may cause injury to you. It is always advisable to start drawing through the tube quickly and gradually slow down. Remember the slower you inhale, the higher the temperature of the air that would warm the material in the Wand.

Step 6: Do not draw too much vapor at the same time, inhale at regular intervals instead of continuous. If you draw in too much then it may lead to coughing. In order to check whether the device is working properly, then see if you are able to exhale a clean and pure white cloud. Do not forget to mix during each draw for better quality of vapors. It is sometimes recommended that you put a drop or two of water. The intensity of the vapor depends upon the moisture content. Lack of smell usually depicts a high quality of vapors.

The simple method will result in getting you the required buzz that you seek. Keep the unit clean and dust free, when not in use. A unit that is switched on, should not be kept unattended for a long time. Maintenance of the vaporizer is very important, it can increase the efficiency of a vaporizer. Firstly, you should keep a check on the power cord and make sure that it is not damaged in anyway. Replacement of different components of a vaporizer depends on the frequency of usage. The screen can be replaced by a 5/8? screen in the Wand.

To replace the screen the following steps should be followed:

Step 1: Pull apart the two parts of the Wand (Upper and Lower)

Step 2: From the upper part, push out the screen

Step 3: Place the new 5/8” screen from the bottom end of the Upper piece of Wand.

Step 4: By rolling back the O-ring onto the upper part of Lower piece of Wand, connect the lower and upper Wand pieces.

Clean the tubing by running it under hot water and using a skewer to scrape out the inner wall. It is suggested that you replace the tubing every 2-3 months. The Wand should be thoroughly cleansed especially when it becomes brown due to usage. In this case, pull the Wand apart and scrape it clean by using a skewer or some other tool. You can also run the Wand under hot water, if the material is difficult to remove.