Step 1: Turn the fan setting to the High (H) position, then turn the unit on. Once you hear the fan has engaged and is up to speed, you can immediately turn the fan to the Low (L) position and begin use.
Step 2: Pre-heat the unit by selecting your desired temperature with the + &- buttons and then press the Heat button.
Step 3: Fill the herb disk with ground material. When the Ready light changes from red to green, insert the disk into the drive, the place drive into unit and begin slowly inhaling.
Step 4: Eject the Herb Disk Drive by pressing the release switch and removing the drawer. Use the supplied tweezers to carefully remove the hot herb disk. Be sure not to touch it, in order to avoid accidental burns.
Step 1: Set the fan to the L position and select your desired temperature.
Step 2: When the actual temperature reaches the set temp, attach the balloon and insert your half filled herb disk into the drawer.
Step 3: Wait about 10 – 15 seconds and then set the fan to the M or H position. The balloon will start to inflate. When using the M fan position to inflate a balloon, you will get a less dense vapor, but it will fill up quicker.
Step 4: When the balloon stops expanding, detach the balloon and inhale. Also turn the fan back down to L to allow the vaporizer to heat back up to the desired temperature.
Step 5: While inhaling, remove the herb drawer so you don’t waste any vapor. When you are finished inhaling the previously filled bag, repeat steps 2 – 4 until desired effects are reached.